×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
thisisshanky Sat, 10/05/2002 - 10:11
User Badges:
  • Purple, 4500 points or more

I guess, the duplex modes is dependent on hardware and not on the type of media used. so it can exist on all media.

svermill Mon, 10/14/2002 - 17:32
User Badges:

Think of the old thin net stuff. You've got a single conductor in that coax cable. Full duplex isn't possible because only one transmitter can be active at any one time. Conversely, with optics you nearly always have a pair of fibers. So it is by nature a full duplex medium.


Yes, arguments could be made against what I just said (you could implement frequency division multiplexing on the coax or something crazy). But where ethernet is concerned, you won't see full duplex via coax. Nor are you likely to see half duplex fiber interfaces (there were fiber hubs for a short period of time but I doubt any are still in use).


Actions

This Discussion