×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Having problens configuring NAT on a cisco router running IOS 12.0.

Unanswered Question
Oct 14th, 2002
User Badges:

I need to enable NAT on a cisco router. There are three interfaces,

serial0, ether0, and ether1. Ether0=10.100.1.1 /24 and ether1=10.200.1.1 /24.

I need to translate the address 10.100.1.2 to address 10.201.1.2. There is

a route to 10.201.1.x /24 thru interface ether1. What would be the correct commands to enable this. I need to access 10.100.1.2(10.201.1.2) from an outside host coming into serial0.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.

Actions

This Discussion