×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Error on VPN 3015 when VPN client trying to connect

Unanswered Question
Oct 19th, 2002
User Badges:

Trying to connect to our VPN concentrator and I get this error. I just started configuring our concentrator not sure if I did it right.


1 10/19/2002 14:22:50.400 SEV=5 IKEDBG/64 RPT=55 64.173.199.201

IKE Peer included IKE fragmentation capability flags:

Main Mode: True

Aggressive Mode: False


3 10/19/2002 14:22:50.620 SEV=4 IKE/165 RPT=25 64.173.199.201

Group [ExternalVPN]

Client IKE Auth mode differs from the group's configured Auth mode


5 10/19/2002 14:22:50.620 SEV=4 IKEDBG/65 RPT=50 64.173.199.201

Group [ExternalVPN]

IKE AM Responder FSM error history (struct &0xa3dddc8)

<state>, <event>:

AM_DONE, EV_ERROR

AM_BLD_MSG2, EV_CHK_PROPOSAL

AM_BLD_MSG2, EV_TEST_CERT

AM_BLD_MSG2, EV_SECRET_KEY_OK


thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
edadios Sun, 10/20/2002 - 17:12
User Badges:
  • Silver, 250 points or more

The cisco software client by default uses the xauth mode for authentication. Make sure the client with xauth ike is active and on top of the list under the CONFIG| SYSTEM| Tunneling protocol | IPSEC | IKE PROP.

Otherwise, see if looking at this sample config helps you (check the concentrator config only) : http://www.cisco.com/warp/customer/471/vpn3k_linux_7203.html .

Regards,


Actions

This Discussion