×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

1600 Setup as bridge

Unanswered Question

Um, are you sure that you want to be doing this? You didn't provide very much detail in your question, but

bridge 1 protocol ieee

no ip routing

int

bridge-group 1

int

bridge-group 2

will turn the router into a straight bridge. NB: Because you have entered "no ip routing" the device will ONLY be a bridge (and you may want to have console access before doing this!). If you post more info about what you are trying to accomplish (and why!) I can provide a better solution....

5sdrexel Wed, 10/23/2002 - 05:12
User Badges:

Wouldn't the bridge-group command on the second interface be "bridge-group 1" instead of 2 ? That is just my understanding of how bridge groups work.

Actions

This Discussion