10-25-2002 12:37 AM - edited 03-02-2019 02:22 AM
How can I get a connection via Gbic between these differents switches. Both switches are not using Vlan but are use like a hub.
Which config should I enter into both catalyst. (full duplex, negociation...)
Solved! Go to Solution.
10-25-2002 03:52 AM
Should not put autonegotiate in both sws and no full duplex. Set same speed in both.
MP
10-25-2002 04:55 AM
No the gbic on the c3548 isn't 100/1000, it is only 1000 Mbps. So you never will be able to connect the bs450 to the C3524, if you not buy an gbic 1000 Mbps to the bs450.
MP
10-25-2002 03:52 AM
Should not put autonegotiate in both sws and no full duplex. Set same speed in both.
MP
10-25-2002 04:15 AM
I've tried but it still doesn't work. Is there something else to add into the c3548 ?
10-25-2002 04:41 AM
Ont the Baystack the line is up but not on the catalyst. The speed on the c3548 is 1000 and 100 on the baystack.
How can I change the speed on the c3548 ?
10-25-2002 04:55 AM
No the gbic on the c3548 isn't 100/1000, it is only 1000 Mbps. So you never will be able to connect the bs450 to the C3524, if you not buy an gbic 1000 Mbps to the bs450.
MP
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: