10-29-2002 08:41 AM - edited 03-02-2019 02:27 AM
We are currently in the process of installing approx 25 new C6509 with the following module layout & versions:
1 1 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes ok
2 2 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes standby
3 3 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok
5 5 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok
7 7 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok
8 8 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok
9 9 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok
WS-X6K-SUP1A-2GE SAL0607J6HG Hw : 7.1
Fw : 5.3(1)
Fw1: 5.4(2)
Sw : 6.3(7)
Sw1: 6.3(7)
WS-F6K-PFC SAL0603GU2J Hw : 2.0
WS-X6348-RJ-45 SAL06334L43 Hw : 6.1
Fw : 5.4(2)
Sw : 6.3(7)
WS-F6K-VPWR Hw : 1.0
We have been experiencing the below line card errors which has occasionally affected single ports or sometimes all ports on a WS-X6348-RJ-45.
2002 Oct 28 14:58:57 GMT +00:00 %SYS-3-SYS_LCPERR3:Module 3:Coil Pb Rx Underflow Error - Port #20:
2002 Oct 28 14:58:57 GMT +00:00 %SYS-0-SYS_LCPERR0:Module 3: Coil Pb Rx Parity Error - Port #20:
This has now occured on approximately 5 out of 25 of the newly installed modules. At first I have been putting this down to a faulty ASIC and replacing the cards. I am consolidating the serial numbers in case of a faulty batch. The DOA rate seems suspicously high!
Has anybody experienced this problem whilst running Catos 6.3(7)? Did a software upgrade fix the problem.
Cheers, John.
10-29-2002 09:50 AM
John
I have encountered this several times . It was identified as a bug CSCdu03935 .
10-29-2002 12:02 PM
It could either hardware or a software. Take a look at the following page on CCO
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: