×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

INSTALL FLASH

Unanswered Question
Nov 1st, 2002
User Badges:

I have a switch (2924) that has no flash in it. When I boot I get this message:


The system has been interrupted prior to initializing the

flash filesystem. The following commands will initialize

the flash filesystem, and finish loading the operating

system software:


flash_init

load_helper

boot


dir on flash-init shows nothing. I understand that TFTP is used to get the IOS image down, but how do I get TFTP from here. I can't figure out the way to configure the switch to use TFTP for it's image.


Any help is very appreciated

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
thisisshanky Fri, 11/01/2002 - 17:08
User Badges:
  • Purple, 4500 points or more

Hi,


I doubt if the this will work. I dont have a 2900 right now with me to try this out....but you could try this...


at the switch: prompt...try


switch: boot tftp:\\ x.x.x.x\


Hopefully if this works....you are in luck...Again... i am not sure abt this....command being supported.


Actions

This Discussion