×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

APs Fail to Reconnect After a Power Failure

Unanswered Question
Nov 13th, 2002
User Badges:

I have some AP-350's failing to reconnect to their parent switches - Cat 5000's and Cat 5500's - after a power failure and resumption. Firmware is 11.10T. It looks like it consistently happens when power is fed from the in-line power injector but I'm not sure. Has anyone seen this before?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tepatel Thu, 11/14/2002 - 09:35
User Badges:
  • Cisco Employee,

Are you using in-line power or power injector?

Does AP comeup at all with in-line power?

There is one issue reported where re-connect of eth cable to AP does resolve the issue..

Try to use the power injector and see the results

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode