×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Configuring a switch

Unanswered Question
Nov 19th, 2002
User Badges:

Is it possible to configure all the ports on a switch at the same time or do they have to be configured one by one. I would like to change the duplex setting on all ports to Full instead of Auto. If this can be done what is the correct syntax?

Thanks in advance.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
deilert Tue, 11/19/2002 - 12:46
User Badges:
  • Silver, 250 points or more

If this is a Catalyst IOS You can not change all ports but you can do a range i.e to change the duplex on ports 3/1 to 3/24 the syntax is


set port duplex 3/1-24 full

kmcvey Tue, 11/19/2002 - 14:12
User Badges:

Yes this is for a Catalyst 3548XL switch Version 12.0(5.3)WC(1). I tried the Set command in privaleged mode but it doesn't seem to understand it.


SW2#set port duplex 0/1-48 full

^

% Invalid input detected at '^' marker.


If I type Set ? it doesn't display any sub-commands. Am I missing something?


Actions

This Discussion