×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

VMS 2.1 ,IDS MC and IDS configuration

Unanswered Question
Nov 20th, 2002
User Badges:

Hi, I would like to know if it's possible configure signatures on a IDS directly with IDS MC or i must use IDS device Manager. If i have more than 50 IDS and i want to change a global signature i must configure each sigle IDS and it's take long time.I see that in IDS MC there is the possibility to add a lot of IDS on the same group but i can't do anything else.

Many thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
larrjone Wed, 11/20/2002 - 13:33
User Badges:

In the current release of the IDS MC, you cannot configure signatures at the group level. This is planned for a future release. However, you can configure the signatures for 1 sensor and then use the Copy wizard to copy the settings to multiple sensors. The Copy wizard is located under the Configuration tab.

Actions

This Discussion