×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Help On Matip needed

Unanswered Question

I was not sure where to post this but, I am desperately in need of some help...

We are currently configuring MATIP on 3600 routers....but we seem to be stuck on finding info on a single command....the rest is ok!

See below, where/how do we obtain the loc-hld figure?


alps local-hld loc-hld (Hexadecimal number in the range 1 to FFFF)

This specifies the local high-level designator (HLD) for an ALPS circuit.


I've searched everywhere and asked many people.....

Please check below for further details. ..

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t5/alpmatip.htm#xtocid35

Any assistance will be greatly appreciaited.

many thanks

Ravi

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
fmeetz Wed, 12/11/2002 - 08:43
User Badges:
  • Bronze, 100 points or more

HLd is the Designator that logically identifies the peer session endpoints used if the multiplex in the circuit is set to group. Loc-hld of the device that is being replaced.

You can refer to the following URLs :

http://www.cisco.com/univercd/cc/td/doc/cisintwk/ita/h12.htm

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800ca776.html#1013893.



Actions

This Discussion