I was not sure where to post this but, I am desperately in need of some help...
We are currently configuring MATIP on 3600 routers....but we seem to be stuck on finding info on a single command....the rest is ok!
See below, where/how do we obtain the loc-hld figure?
alps local-hld loc-hld (Hexadecimal number in the range 1 to FFFF)
This specifies the local high-level designator (HLD) for an ALPS circuit.
I've searched everywhere and asked many people.....
Please check below for further details. ..
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120t/120t5/alpmatip.htm#xtocid35
Any assistance will be greatly appreciaited.
many thanks
Ravi