Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

NM-1A-E3 not identified cisco2611

Answered Question
Dec 11th, 2002
User Badges:


I have a new NM-1A-E3 Modul installed, HW-SW Matrix checked, correct ios downloaded, but Modul is not visible.

%PA-2-UNDEFPA: Undefined Port Adaptor type 427 in bay 1

Maybe ROM Version wrong ?

sh stack is ok.

Thanks Ruedi

Additional infos : sh vers, sh flash

Router#sh ver

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-JS-M), Version 11.3(5)T, RELEASE SOFTWARE (fc1)

Copyright (c) 1986-1998 by cisco Systems, Inc.

Compiled Wed 12-Aug-98 03:31 by ccai

Image text-base: 0x80008084, data-base: 0x80A31118

ROM: System Bootstrap, Version 11.3(2)XA3, PLATFORM SPECIFIC RELEASE SOFTWARE (f


Router uptime is 4 minutes

System restarted by power-on

System image file is "flash:c2600-js-mz.113-5.T.bin", booted via flash

cisco 2611 (MPC860) processor (revision 0x202) with 36864K/12288K bytes of memor


Processor board ID JAB024905LP (980524050)

M860 processor: part number 0, mask 49

Bridging software.

X.25 software, Version 3.0.0.

SuperLAT software copyright 1990 by Meridian Technology Corp).

TN3270 Emulation software.

2 Ethernet/IEEE 802.3 interface(s)

1 Serial network interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102


Router#sh flash:

System flash directory:

File Length Name/status

1 5808072 c2600-js-mz.113-5.T.bin

[5808136 bytes used, 10969080 available, 16777216 total]

16384K bytes of processor board System flash (Read/Write)


Correct Answer by atimpanaro about 14 years 8 months ago
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
rburkhard Wed, 12/11/2002 - 02:29
User Badges:

Hello, I have tried with 12.1(2)T as described in HW-SW Matrix. Same effect.

Regards Ruedi

rburkhard Wed, 12/11/2002 - 05:18
User Badges:

Hello Andrea,

That was it ! Now its ok.

Could I find this information (ip plus necessary) in IOS Rel. notes ?

For further cases...

Thanks for your help




This Discussion