cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
266
Views
0
Helpful
2
Replies

EIGRP questions

felipe.lopez
Level 1
Level 1

Hi! I have actually running EIGRP between two routers over a frame relay link. I have two PVCs are operating over the same link one with CIR 384 the other CIR 128 kbps. The first PVC its EIGRP preferred to transmit information, but I am wasting bandwith...How I can balance the trasmit information between two PVCs??

Thanks for your help Felipe

2 Accepted Solutions

Accepted Solutions

vmiller
Level 7
Level 7

Although this document refers to IGRP, it still applies to EIGRP. This should

get you on the way.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ip_c/ipcprt2/1cdigrp.htm#1001028

View solution in original post

prafuljaded
Level 3
Level 3

U can use variance command in Eigrp for unequal load balancing.

In ur scenario, u can use variance 3.

Check out this link:

http://www.cisco.com/warp/public/103/19.html

View solution in original post

2 Replies 2

vmiller
Level 7
Level 7

Although this document refers to IGRP, it still applies to EIGRP. This should

get you on the way.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ip_c/ipcprt2/1cdigrp.htm#1001028

prafuljaded
Level 3
Level 3

U can use variance command in Eigrp for unequal load balancing.

In ur scenario, u can use variance 3.

Check out this link:

http://www.cisco.com/warp/public/103/19.html

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: