×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Desperate search for this answer

Unanswered Question

Heres the # to the question as asked in the Cisco testing software that accompanies the 640-607 certification kit. It is the esim question that asks you to set the serial links up and ping them between the router. I have my exam saturday and if anyone can figure this out I will be in their debt.


Question # 3504


Thanks very much guys, if you have the software you'll know what question I'm talking about.

Dave

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
j.stringer Wed, 01/08/2003 - 06:07
User Badges:

I'm not too sure on the politics of answering your question, but if it is the same question I had (simulation question, can't ping between two routers, troubleshoot and reslove issue??) .... I would suggest you check the configuration of the two connected interfaces. BE THOROUGH !!! (I can't just GIVE you the answer) Good luck on the exam. Sorry if this isn't what you're loking for.


Regards

Actions

This Discussion