01-09-2003 09:17 AM - edited 03-02-2019 04:03 AM
In a 7206 I am only allowed a certain amount of 'bandwidth' per box, which makes me have to be particular with what modules I can install. Is there a command that will tell me what bandwidth is already used up so I can decide if I can install certain blades?
01-09-2003 12:56 PM
Bandwidth usage is dynamic. You will have to use a product like concord to poll the interfaces.
01-09-2003 04:08 PM
Depends on which NPE you have.
for the NPE 200 it depends on the amt of SRAM, figure 3 high speed ints.
(100bm or >)
for NPE 225s
Its on a "points" basis. with 600 points per bus. use full duplex numbers for any interface..i.e 200mb for faste 32 mb for token ring ( I just know you guys still have some).....
The bellevue S.E.s have a doc...I'll try and root it out
01-10-2003 09:47 AM
I emailed you the doc on 7200 b/w capacity
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide