01-20-2003 11:23 PM - edited 03-02-2019 04:22 AM
I have 1601, i cannot access the router through console port , session dos not
start.
any solution for this
manish young
01-20-2003 11:46 PM
Did u check the cable, and the connectors used to access the console ??
Also please check the Hyperterminal (or the software u r using) settings...?? It should 9600 8 1 No flow control..
Hope that helps..
01-21-2003 12:51 AM
hi agian,
i have tried diffrent connectors & correct hyper terminal setting, but it dosent work.
manish young
01-21-2003 01:03 AM
Assuming the router is not active/running,
if you have used/done the following:
1. Correct COM port and Hyperterm settings:
- 9600 baud
- 8 databits
- no parity
- 1 stop bit
- no flow control
2. Correct and working console cable
(A console cable that was previously used in other routers or switch)
and if nothing is displayed in your teminal window after powering ON the
router, then it could be a defective console port or probably a defective router.
01-21-2003 03:47 AM
thanks,
i think my router's console port is gone ,bec i can access through telnet
with regards
manish young
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: