×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Configuring SNMP variables on CatIOS

Answered Question
Jan 22nd, 2003
User Badges:

Anyone know what are the commands needed to configure the chassis ID on a CatIOS switch? That is I'm looking for something equivalent to the command "snmp chassis-id" on an IOS switch/router. Thanks in advance.

Correct Answer by milan.kulik about 14 years 7 months ago

Hello,

AFAIK there is a SNMP engine ID used on CatOS but you are not able to change it.

I'm using set system location or set system contact to define my device inventory numbers.

Regards,

Milan

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
milan.kulik Wed, 01/22/2003 - 23:44
User Badges:
  • Red, 2250 points or more

Hello,

AFAIK there is a SNMP engine ID used on CatOS but you are not able to change it.

I'm using set system location or set system contact to define my device inventory numbers.

Regards,

Milan

Actions

This Discussion