Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
248
Views
0
Helpful
1
Replies

Configuring SNMP variables on CatIOS

Go to solution
vincent-n
Level 3
Level 3

‎01-22-2003 03:53 PM - edited ‎03-02-2019 04:26 AM

Anyone know what are the commands needed to configure the chassis ID on a CatIOS switch? That is I'm looking for something equivalent to the command "snmp chassis-id" on an IOS switch/router. Thanks in advance.

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
milan.kulik
Level 10
Level 10

‎01-22-2003 11:44 PM

Hello,

AFAIK there is a SNMP engine ID used on CatOS but you are not able to change it.

I'm using set system location or set system contact to define my device inventory numbers.

Regards,

Milan

View solution in original post

0 Helpful
1 Reply 1

Go to solution
milan.kulik
Level 10
Level 10

‎01-22-2003 11:44 PM

Hello,

AFAIK there is a SNMP engine ID used on CatOS but you are not able to change it.

I'm using set system location or set system contact to define my device inventory numbers.

Regards,

Milan

0 Helpful
Customers Also Viewed These Support Documents