×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

RADIUS Support for Dynamic Access Lists

Unanswered Question
Jan 23rd, 2003
User Badges:

Hello,


We are currently running a Vircom RADIUS server on a VoIP Network. We would like to have a firewall or dynamic ACL that will permit or deny H323 traffic in and out based on RADIUS AAA.


The actual application is to allow low density gateways (i.e. ATA 186's) with dynamic IP addresses that are registered to our gatekeeper with H323 ID's to access our 5300's to terminate calls to the PSTN.


Any ideas?


Thanks in advance!

Albert

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
murabi Wed, 01/29/2003 - 12:49
User Badges:

The following is a known bug on 5300, Dynamic access list works from 11.1.


CSCdk82279

Authentication using a Vircom RADIUS server stops working after you upgrade to Cisco IOS Release 11.3(6)T1 on a Cisco 5300 series access server.

There is no known workaround.


The following URL will give you an example of configuring ACL

http://www.cisco.com/en/US/products/sw/secursw/ps1018/products_tech_note09186a00800a5b9a.shtml#time

Actions

This Discussion