×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Removal of static, conduit, and route commands

Answered Question

I can't seem to find this in the docs anywhere - how does one remove static, conduit, and route commands on a Pix 515, v5.3? Can one simply type the word 'no', followed by the command?


Thanks.

Correct Answer by tvanginneken about 14 years 6 months ago

Hi,


one can simply type 'no' followed by the command. But you have to be in config mode to do this.


Kind Regards,

Tom

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
tvanginneken Fri, 01/24/2003 - 15:02
User Badges:
  • Silver, 250 points or more

Hi,


one can simply type 'no' followed by the command. But you have to be in config mode to do this.


Kind Regards,

Tom

Actions

This Discussion