How can I configure no service pad command in CatOS?

Unanswered Question
Feb 20th, 2003
User Badges:

hi, i'm a network engineer in japan.

i need a help from you. i wanna configure no service pad command in CatOS.

i can't find any set command in WS-C4003 Software, Version NmpSW: 6.3(2a).

and what's PAD(packet Assembler/Disassembler)??

also, i can't set telnet password in CatOS.

i would appreciate your help.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Georg Pauwen Fri, 02/21/2003 - 00:55
User Badges:
  • Green, 3000 points or more
  • Cisco Designated VIP,

    2017 WAN


AFAIK, the service pad only applies to Cisco IOS, and there is no equivalent fo this in CatOS.

As to setting the password for TELNET sessions, set the password first:

set password xxxx

set enablepass xxx

and then define the authentication for the TELNET sessions (depending on what you use, the example below is for TACACS):

set authentication login tacacs enable telnet primary



arryok Sun, 02/23/2003 - 17:16
User Badges:

thank you very much.

i appriciate your help.


This Discussion