How can I configure no service pad command in CatOS?

arryok · ‎02-20-2003

hi, i'm a network engineer in japan.

i need a help from you. i wanna configure no service pad command in CatOS.

i can't find any set command in WS-C4003 Software, Version NmpSW: 6.3(2a).

and what's PAD(packet Assembler/Disassembler)??

also, i can't set telnet password in CatOS.

i would appreciate your help.

thanks.

Georg Pauwen · ‎02-21-2003

Hello,

AFAIK, the service pad only applies to Cisco IOS, and there is no equivalent fo this in CatOS.

As to setting the password for TELNET sessions, set the password first:

set password xxxx

set enablepass xxx

and then define the authentication for the TELNET sessions (depending on what you use, the example below is for TACACS):

set authentication login tacacs enable telnet primary

Regards,

Georg

arryok · ‎02-23-2003

thank you very much.

i appriciate your help.