Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1544
Views
0
Helpful
1
Replies

Port Binding for aggregating bandwidth

bob.bartlett
Level 1
Level 1

‎03-20-2003 11:06 AM - edited ‎03-02-2019 06:01 AM

I have a 4006 with a WS-X4148 module and a Supervisor IV module in it. I can only connect to a backbone switch with the 100MPS ethernet ports. Is there a way to take 3 ports and virtually bind them together so that I can get 300 MPS of throughput? If so, how do I do that?

Labels:
0 Helpful
1 Reply 1

donewald
Level 6
Level 6

‎03-21-2003 06:44 AM

Etherchannel will enable you to bind your FastEthernet interfaces. Please see the following link for directions on how to accomplish this.

http://www.cisco.com/en/US/partner/products/hw/switches/ps663/products_configuration_guide_chapter09186a008007d445.html

Regards,

Don

0 Helpful
Customers Also Viewed These Support Documents