×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

I don't know if you got your answer to your question.

Normally a CDR record isn't logged until the switch received disconnect supervision for either end. This is because the record is written after the length of call is determined.


What you are looking for is a snap shot or a looping trace on a TN/DN.



What you probably are looking for is a real time trace. I'm new to Call Manager, I have done some CDR analysis from data received from Rolm and Nortel switches.



Actions

This Discussion