×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Connectivity Problem with NM 4T & WIC 2T

Unanswered Question
Mar 31st, 2003
User Badges:

Hi,

I have Cisco Router 2610 with WIC 2T, & Cisco Router 3640 with NM 4T.

Connected back to back.

What is the configuration should i apply for this routers to make a connection.

Also i want to know compatilibity of NM 4T with 2610 Router.


Regards,

Mudassir.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
a.manosca Mon, 03/31/2003 - 00:56
User Badges:
  • Bronze, 100 points or more

There should be no special configuration required when connecting the routers back-to-back. We have even tried connecting a 1700 with the 3640's NM-4T with no problem. Just set the IP addresses on both routers and a clocking on the router with the DCE cable. NM-4T is not supported on 2600 series.

mmali Mon, 03/31/2003 - 01:13
User Badges:

I tried clocking 115200. but it is not excepting it.

it is taking 240.

interface shows down down.


Actions

This Discussion