Command "switchport port-security violation shutdown"

Answered Question
Mar 31st, 2003

Hi all,

When use port-security in the switch, we use switchport port-security mac-address x.x.x to config the port, but what's the difference with the "switchport port-security violation shutdown" command? Thank You!

Best Regards

Teru Lei

I have this problem too.
0 votes
Correct Answer by ndoshi about 12 years 3 weeks ago

shutdown—When a port security violation occurs, the interface is error-disabled and the port LED is off. When a secure port is in the error-disabled state, you can bring it out of this state by entering the errdisable recovery cause psecure-violation global configuration command, or you can manually re-enable it by entering the shutdown and no shutdown interface configuration commands. This is the default mode.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a0080150bcd.html

Nilesh

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Correct Answer
ndoshi Mon, 03/31/2003 - 19:06

shutdown—When a port security violation occurs, the interface is error-disabled and the port LED is off. When a secure port is in the error-disabled state, you can bring it out of this state by entering the errdisable recovery cause psecure-violation global configuration command, or you can manually re-enable it by entering the shutdown and no shutdown interface configuration commands. This is the default mode.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a0080150bcd.html

Nilesh

Actions

Login or Register to take actions

This Discussion

Posted March 31, 2003 at 5:30 PM
Stats:
Replies:1 Overall Rating:5
Views:346 Votes:0
Shares:0
Tags: No tags.
 

Discussions Leaderboard

Rank Username Points
1
thisisshanky
2,069
2
pkhatri
1,746
3
ankurbhasin
1,704
4
gpauwen
1,629
5
Richard Burts
1,583
Rank Username Points
Leo Laohoo
10
Joseph W. Doherty
5
mendixbeevee
5
pablo1711
5
xavierchang@hot...
5