CM install on clone hardware

aungureanu · ‎04-02-2003

I am trying to install CM on clone hardware (not on the approved Cisco hardware list) to test different configurations and to test the upgrade from 3.2 to 3.3 but I don't seem to figgure it out.

Can any of you help me in twiking the install to accept non-approved hardware for testing purposes?

Thank you,

Alin

rickb · ‎04-03-2003

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB?cmd=display_location&mode=new&location=.ee7ff9e/8

markl · ‎04-15-2003

stiStage /o will not work on cm3.3. you will need to modify the registry in several places

Mark

aungureanu · ‎04-15-2003

And what are the registry that need to be changed? I presume where the hardware info is stored. I have tried to do so but I aparently am mising somthing.

If you have succeded in this please e-mail me the registry and what info is needed.

Thank you.

Alin