×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Missing serials on 2503 ?

Answered Question

I can't "see" serials intf on one 2503 I got over today. Just a brio and eth0. Are they defect or is there a prob with IOS/RAM/FLASH ?

sh ver:

IOS (tm) 3000 Software (IGS-G-L), Version 11.0(5), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-1996 by cisco Systems, Inc.

Compiled Mon 05-Feb-96 23:39 by hochan

Image text-base: 0x0301C994, data-base: 0x00001000


ROM: System Bootstrap, Version 5.2(5), RELEASE SOFTWARE

ROM: 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(5), RELEASE SOFTWARE (fc

1)


Router uptime is 17 minutes

System restarted by power-on

System image file is "flash:ii11050n.", booted via flash


cisco 2500 (68030) processor (revision D) with 1020K/1024K bytes of memory.

Processor board ID 01975602, with hardware revision 00000000

Bridging software.

Basic Rate ISDN software, Version 1.0.

1 Ethernet/IEEE 802.3 interface.

1 ISDN Basic Rate interface.

32K bytes of non-volatile configuration memory.

4096K bytes of processor board System flash (Read ONLY)


Configuration register is 0x2102

Correct Answer by bbranch about 14 years 4 months ago

The image you are running (IGS-G-L) is one of the special 2500i ISDN and Ethernet only images Cisco produced (lower retail cost than full 2500 image), this image does not support the serial interfaces.





  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
bbranch Thu, 04/10/2003 - 06:38
User Badges:
  • Silver, 250 points or more

The image you are running (IGS-G-L) is one of the special 2500i ISDN and Ethernet only images Cisco produced (lower retail cost than full 2500 image), this image does not support the serial interfaces.





Actions

This Discussion