04-10-2003 05:43 AM - edited 03-02-2019 06:33 AM
I can't "see" serials intf on one 2503 I got over today. Just a brio and eth0. Are they defect or is there a prob with IOS/RAM/FLASH ?
sh ver:
IOS (tm) 3000 Software (IGS-G-L), Version 11.0(5), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Mon 05-Feb-96 23:39 by hochan
Image text-base: 0x0301C994, data-base: 0x00001000
ROM: System Bootstrap, Version 5.2(5), RELEASE SOFTWARE
ROM: 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(5), RELEASE SOFTWARE (fc
1)
Router uptime is 17 minutes
System restarted by power-on
System image file is "flash:ii11050n.", booted via flash
cisco 2500 (68030) processor (revision D) with 1020K/1024K bytes of memory.
Processor board ID 01975602, with hardware revision 00000000
Bridging software.
Basic Rate ISDN software, Version 1.0.
1 Ethernet/IEEE 802.3 interface.
1 ISDN Basic Rate interface.
32K bytes of non-volatile configuration memory.
4096K bytes of processor board System flash (Read ONLY)
Configuration register is 0x2102
Solved! Go to Solution.
04-10-2003 06:38 AM
The image you are running (IGS-G-L) is one of the special 2500i ISDN and Ethernet only images Cisco produced (lower retail cost than full 2500 image), this image does not support the serial interfaces.
04-10-2003 06:38 AM
The image you are running (IGS-G-L) is one of the special 2500i ISDN and Ethernet only images Cisco produced (lower retail cost than full 2500 image), this image does not support the serial interfaces.
04-10-2003 07:14 AM
Thank you very much for your input.
What is version I should use or what image I should use ? I have a lot of images but I am not shure which one is less "memory-hungry". Or should I go for IOS 12 to get WAN features?
Thank you again...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: