04-17-2003 02:39 AM
hi,
6500 supports multiple CSM modules in one chassis. I check the configuation about the CSM with 2 modes one is rp and another is csm. another mether is to enter the csm module. Does anyone know the current way to setup the 2 csm modules in one 6500 or give me a sample ?
best regards.
fred.
04-18-2003 11:34 AM
If you are running muliple CSM's in the same chassis you need to run in csm mode, otherwise if you are running a single csm in a chassis you can run in rp mode.
hope that helps
I am running one csm in each chassis and fault-tolerant
mark
04-20-2003 08:32 PM
hi,
I can't see any configure about the second CSM in CSM mode.
This is my problem.
best regards.
fred.
04-30-2003 04:25 AM
what do you mean you don't see the config ?
You should create it after entering the following 'mod csm
I have 2 in the same catalyst and I can see the config for both.
Gilles.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide