×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Signature tuning in 4.0

Unanswered Question
May 3rd, 2003
User Badges:

It is very time consuming to locate the particular signature in v4.0 using

Configuration->Sensing Engine->Virtual Sensor Configuration->Signature Configuration Mode..

Page by page is not the best way to navigate.

Is anyway to enter the enter the specific sig. # to edit or have the same navigation as in v3.x using signature ranges for every page?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
kleem Mon, 05/05/2003 - 06:40
User Badges:
  • Cisco Employee,

The signature range information (as it was in 3.1) will be included in the next CIDS release (4.1) to make it easier to locate signatures.

DSmirnov Mon, 05/05/2003 - 15:47
User Badges:

Thanks a lot,


is ETA available for 4.1?


Another pain with 4.0 - it takes 2-3 mins for me to open "Signature Configuration Mode" on loaded sensor.


Plus I can't disable more then one signature at them time. I have the following message during the attempt to Save Changes:


Update failed [Invalid configuration. Restarting the Virtual Sensor .... This may take some time .... ]


I need to logout and login back to disable another signature.

IDS version 4.0.2S43.

Actions

This Discussion