×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

PIX 525 Ver. 6.3(1) & static IP problems

Answered Question

I'm having problems changing static IP addresses to internal IP addresses.

The original statement looked like this,

static (DMZ,outside) xxx.xxx.46.3 192.168.1.2 netmask 255.255.255.255 0 0

When I change the external ip address to point to another internal IP address,

static (DMZ,outside) xxx.xxx.46.3 192.168.1.3 netmask 255.255.255.255 0 0

the new address is listed but the external ip address still points to the old internal address. I can't correct the problem until I reboot the PIX.

Is this some sort of a cache problem.

Correct Answer by rpel about 14 years 3 months ago

Martin,

Do you have a chance to implent the logical interface (virtual interface) ?

As you can see, 6.2(2) pix does not support virtual interface; however, 6.3(1) does. To answer your question, after you did the configuration, you must use

clear xlate command to clear all translations. I hope this would help you.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
rpel Thu, 05/08/2003 - 11:45
User Badges:

Martin,

Do you have a chance to implent the logical interface (virtual interface) ?

As you can see, 6.2(2) pix does not support virtual interface; however, 6.3(1) does. To answer your question, after you did the configuration, you must use

clear xlate command to clear all translations. I hope this would help you.


Actions

This Discussion