×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

TCL IVR script: Problems making a simple call.

Unanswered Question
May 26th, 2003
User Badges:


I'm trying to get a simple TCL IVR script running on a on a 3745 with IOS IP Plus 12.3(1) , but I am not able to setup a call.



The important lines from the tcl-script:


leg proceeding leg_incoming

leg setup 166 callInfo leg_incoming <-- this line generates the error



Here is the outgoing voice peer from the running config.


dial-peer voice 166 voip

destination-pattern 1..

session target ipv4:192.168.100.93

codec g711ulaw


This h323 peer is a simple Netmeeting client on my PC.


Here is the debug output (debug voice ivr all):

6d01h: Destination SetupPeer cid(242), destPat(166), match(1), prefix(), peer(63BE064C)

6d01h: //-1//PCM :HN1F3772A4:/DNSetupPeer: cid(242), can't gateway with peer tag(166)

6d01h: //-1//PCM :HN1F3772A4:/DNInitiate: DestinationSetupPeer Failed.

6d01h: //-1//PCM :HN1F3772A4:/DNCleanup: Terminate=TRUE Status DN_CANTGATEWAY



Any suggestions would be appreciated. It would also be helpful If you know a place where to get simple script examples.



Regards,

Daniel Steinke


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion