×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

QOS Implementation

Unanswered Question

Hi

I have the below setup

CCM--- Switch--- customers Router ----IPLC circuit ---ISP Router -----Output as ethernet to the customer location .

When i install two soft phones between the two locations , without any additional configuration voice is distorted totally .

Soft PHones are present in both the network and US end soft phones are registered to the India CCM. to get a good voice quality is it enough if i implement qos on the India end router alone. Or is there any other better way since at US end customer will get out put from the local ISP as ethernet only & no configurations can be done at US end ISP side

thanx in advance

regards

Sundara Rajan .R

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ivillegas Wed, 06/04/2003 - 07:29
User Badges:
  • Silver, 250 points or more

You have to implement QOS on both ends. Implementing QOS at one end will not fullfill your requirement.

Actions

This Discussion