×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

ISDN PRI: TEI_ASSIGNED status in layer 2

Unanswered Question
Jun 2nd, 2003
User Badges:

My working PRI line says TEI_ASSIGNED at Layer 2 upon issueing the SHOW ISDN STATUS and doesn't take incoming calls from remote router

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
jolmo Mon, 06/02/2003 - 03:16
User Badges:
  • Silver, 250 points or more

You can't take calls because Layer 2 isn't in right state. It should display MULTIPLE_FRAME_ESTABLISHED at Layer 2.

For more information refer to 'E1 PRI Troubleshooting':

http://www.cisco.com/en/US/tech/tk713/tk584/technologies_tech_note09186a00800f9e3a.shtml


'E1 PRI Troubleshooting Flowchart':

http://www.cisco.com/en/US/tech/tk713/tk584/technologies_tech_note09186a00800a70fc.shtml


and 'E1 Troubleshooting':

http://www.cisco.com/en/US/tech/tk713/tk584/technologies_tech_note09186a00800a70fb.shtml


These pages offer very useful flowcharts for troubleshooting PRI lines.


HTH


P.S: I'm also managing PRI lines, and recently installed a new one. When I checked it, I also saw Layer 2 TEI_ASSIGNED. Problem came from Telco provider. They solved it later.

deilert Mon, 06/02/2003 - 04:09
User Badges:
  • Silver, 250 points or more

In the US it should be multi frames established. If you are not in this state it is a carrier problem . Outside the US this is the normal state prior to placing a call.

Actions

This Discussion