×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Etherchannel

Unanswered Question

Hi

i have bundled 2 gig port to form a etherchannel and it workign fine


but when i use this command sh etherchannel detail

-------------------

Port: Gi1/1

------------


Port state = Up Mstr In-Bndl

Channel group = 100 Mode = On/FEC Gcchange = -

Port-channel = Po100 GC = - Pseudo port-channel = Po100

Port index = 0 Load = 0x55 Protocol = -


Age of the port in the current state: 18d:02h:44m:25s


Port: Gi1/2

------------


Port state = Up Mstr In-Bndl

Channel group = 100 Mode = On/FEC Gcchange = -

Port-channel = Po100 GC = - Pseudo port-channel = Po100

Port index = 1 Load = 0xAA Protocol = -


Age of the port in the current state: 18d:02h:48m:18s



Why is the Mode= on/FEC...y is it showning FEC when it has to be GEC...right am doin a layer 2 etherchanneling


Please throw some light on it


Raj

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
vmoopeung Thu, 06/26/2003 - 07:42
User Badges:
  • Bronze, 100 points or more

Good catch. It is a cosmetic bug, i suppose. May be Cisco uses the same code to display both the GEC and FEC, hence this display. You could contact cisco to open a bug if it really bothers you!

Actions

This Discussion