×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

which "lane" command correct?

Unanswered Question
Jun 24th, 2003
User Badges:
  • Bronze, 100 points or more

Dear all,

I have seen two types of commands to configure LEC on Atm lane modules.


"lane client 1 ELAN1" and "lane client ELAN1", in which for first command "1" is VLAN-id. Which is correct command?


Thanks in advance..


Regards...


Ashok.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
gmarogi Tue, 07/01/2003 - 08:16
User Badges:
  • Bronze, 100 points or more

I think both of them are correct. The first one is used on a switch to bind a vlan to the ELAN. The second one is used on a router which can route between different ELANs configured under different sub-interfaces.


Actions

This Discussion