Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
224
Views
0
Helpful
1
Replies

which "lane" command correct?

ashok_boin
Level 5
Level 5

‎06-24-2003 11:03 PM - edited ‎03-02-2019 08:23 AM

Dear all,

I have seen two types of commands to configure LEC on Atm lane modules.

"lane client 1 ELAN1" and "lane client ELAN1", in which for first command "1" is VLAN-id. Which is correct command?

Thanks in advance..

Regards...

Ashok.


With best regards...
Ashok
Labels:
0 Helpful
1 Reply 1

gmarogi
Level 5
Level 5

‎07-01-2003 08:16 AM

I think both of them are correct. The first one is used on a switch to bind a vlan to the ELAN. The second one is used on a router which can route between different ELANs configured under different sub-interfaces.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents