06-25-2003 07:55 AM - edited 03-02-2019 08:25 AM
SSA-SSA-SSA> (enable) sh mod
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1 1 2 1000BaseX Supervisor WS-X6K-SUP2-2GE yes ok
15 1 1 Multilayer Switch Feature WS-F6K-MSFC2 no ok
2 2 2 Network Analysis Module WS-X6380-NAM no ok
Module 2 mismatch of config and actual type. Ports disabled
Config: 16-port 1000BaseX , Actual: Network Analysis Module
Insert config module type or do a 'clear config 2'
3 3 16 1000BaseX Ethernet WS-X6416-GBIC no ok
4 4 16 1000BaseX Ethernet WS-X6416-GBIC no ok
6 6 48 10/100BaseTX Ethernet WS-X6348-RJ-45 no ok
7 7 48 10/100BaseTX Ethernet WS-X6348-RJ-45 no ok
8 8 48 10/100BaseTX Ethernet WS-X6348-RJ-45 no ok
9 9 48 10/100BaseTX Ethernet WS-X6348-RJ-45 no ok
We relocated NAM from site to another and I reconfigured it. I tried resetting, but still get mis match error.
06-25-2003 09:02 AM
What is the software version running on this NAM and the switch above?
06-30-2003 09:42 AM
Hi Richard,
The slot2 was probably occupied by another linecard or supervisor in the past. Configuration is retained when installing a module in this slot. So do as the message advise you. do a
Regards,
Frank
06-30-2003 11:28 AM
Thanks the second reply fixed my problem.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: