Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
422
Views
0
Helpful
1
Replies

Router 1760 and WIC-1T

santo.suy
Level 1
Level 1

‎06-27-2003 05:01 AM - edited ‎03-02-2019 08:28 AM

I have two routers 1760 serie with a WAN card WIC-1T inserted in slot 0.

Unfortunetly, I cannot use the command "controller E1 0/0" in order to configure the source of the clock.

Nor can I use the command "sh controller E1".

The command "show diag" tells me that the card WIC-1T has been recognized by the router.

Where is the problem ? Is there a special image that I should use ?

My IOS image file is : c1700-sy-mz.122-11.T8.bin

Thank you for your reply.

Labels:
0 Helpful
1 Reply 1

lgijssel
Level 9
Level 9

‎06-27-2003 05:51 AM

If you intend to use a WIC-1T as controller for a 2Mb G703 link, you probably have the wrong module. The WIC-1T can only be used to connect to a conventional leased line. It will show in the config as int serial ..

To connect a structured or unstructured G703 you will need something like the VWIC-1MFT-G703. Please have a look at the following link to the product specs for these modules:

http://www.cisco.com/en/US/products/hw/routers/ps221/products_data_sheet09186a0080088715.html

Regards,

Leo

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents