×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Issue with reverse Telnet

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
deilert Thu, 07/03/2003 - 03:52
User Badges:
  • Silver, 250 points or more

did you change the escape character ?

rjackson Thu, 07/03/2003 - 06:09
User Badges:
  • Bronze, 100 points or more

Show line on the interface you are connecting to the 2509 with. If you are telneting it is a vty interface. This will show you the escape character that is set. When 2509 is used to access routers the escape is usually changed so the normal sequence will work on the router you are reversed telnetd to.

deilert Thu, 07/03/2003 - 09:27
User Badges:
  • Silver, 250 points or more

the above posts states how to find it

do a sh line xx


>sh line 66

Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int

* 66 VTY - - - - - 167 0 0/0 -


Line 66, Location: "", Type: "XTERM"

Length: 57 lines, Width: 141 columns

Baud rate (TX/RX) is 9600/9600

Status: PSI Enabled, Ready, Active, No Exit Banner, Automore On

Capabilities: none

Modem state: Ready

Group codes: 0

Special Chars: Escape Hold Stop Start Disconnect Activation

^^x none - - none

Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch

00:15:00 00:15:00 none not set


milan.kulik Fri, 07/04/2003 - 04:44
User Badges:
  • Red, 2250 points or more

Hi,

are you connected via console port and doing reverse telnet connection then?

If yes, Ctrl-Shift-6 x should work with no problem.

Don't forget: Ctrl-Shift-6, release keyboard and then press x.

If you are using telnet as primary access to the 2509 and doing reverse telnet to the device then, simply close the Hyperterminal window and open a new session to connect to a different device.

Regards,

Milan


deilert Mon, 07/07/2003 - 16:03
User Badges:
  • Silver, 250 points or more

When you do a cntrl shif t 6 it only suspends your session , if you want to terminate your session type exit on the 1720 or do a cntrl shft 6 x then on the 2509 clear the line you just accessed .



i.e If your session was connected over async line 2 type clear line 2 . a show line will show you what line you are connected on .

rjackson Tue, 07/08/2003 - 05:55
User Badges:
  • Bronze, 100 points or more

The disconnect command (disc) is the correct way to close the session after retruning to the 2509. Entering a blank line (return) will resume the last session if it has not been discconected. Show session ( on the 2509) shows the current sessions. Eventually you will want to connect to multiple routers at the same time. When you return to the 2509 you enter the session number of the router you want to connect back to.

Actions

This Discussion