I have an IPSEC VPN established between 2 501 PIX's currently connected with a cross over cable (testing before we go live). I can ping thru, pc to pc fine. I can browse with an IP address and a share name on the remote pc fine.
But, I cannot (Microsoft Netbios) browse thru the vpn with Windows 2000. How can this be done? The Conduit is wide open, but it still doesn't browse thru. I also will be installing active directory on a Win2k domain controller on one side of the VPN to a domain controller on the other side. This needs name lookup as well.
Clues? Ideas? How can I browse thru the VPN?
Current config (purposely "over" opened conduits) just to try to get it to work:
access-list 101 permit ip 10.0.0.0 255.255.255.0 192.168.1.0 255.255.255.0
pager lines 24
interface ethernet0 10baset
interface ethernet1 10full
mtu outside 1500
mtu inside 1500
ip address outside 184.108.40.206 255.255.255.240
ip address inside 10.0.0.200 255.255.255.0
ip audit info action alarm
ip audit attack action alarm
pdm logging informational 100
pdm history enable
arp timeout 14400
nat (inside) 0 access-list 101
conduit permit icmp any any
conduit permit ip any any
route outside 0.0.0.0 0.0.0.0 220.127.116.11 1