×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
dgoodwin Tue, 07/15/2003 - 05:34
User Badges:
  • Cisco Employee,

I haven't heard of this personally. However, if I were designing a network that will carry voice or other real-time traffic, I would avoid Gigastack whenever possible due to its half-duplex nature. If there were ever a problem that caused a high collision rate, I would be pretty unhappy.

chris.schuerger... Sat, 07/19/2003 - 09:54
User Badges:

The Gigastack modules only operate in half-duplex if you use both 'ports' on them. If you are only using one gigastack cable per gigastack GBIC, then it should run in Full-Duplex

Actions

This Discussion