CNR ver 5.5 - slow GUI performance across MT WAN

Unanswered Question
Jul 28th, 2003
User Badges:

Has anybody experienced slow response with the CNR GUI when connecting to a CNR server across WAN links? If I attempt to config a secondary zone on a remote CNR server I get a 2 minute delay opening the [email protected], chosing Add, inserting a name and selecting secondary. The WAN has 20 ms latency across t1 links that are MT.


I have seen probs with cisco's mgt aps where they get pretty picky about calling by IP address or FQDN. FQDN makes a drastic improvement in PIX PDM. I have tried both ways in this CNR case.


Anybode else been there?


Regards


Richard


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
keyushah Mon, 07/28/2003 - 09:56
User Badges:

Richard,

Please attempt to "refresh record indexes" by going to the DNS -> debug tab. This should improve performance significantly. The GUI performance is generally not so great, and hence the move to a web based UI from 6.0.


thanks

Keyur

Actions

This Discussion