michelpe Tue, 09/16/2003 - 22:55
User Badges:
  • Cisco Employee,

There is a Mac-Address assigned per port for the Spanning Tree

Protocol


This is viewable via show interface or show port mac-address

axfalk Wed, 09/17/2003 - 07:01
User Badges:

Thanks for your response. Unfortunately, I could not get this command to work on a Cat-2980G switch. I was able to get the range of MAC addresses on the module on a switch by using the "sh module" command, however nothing on a port level basis.

Actions

This Discussion