No dial-tone call forward ITS 3.01 to PBX (Ascotel 64)

pf · ‎09-25-2003

The caller from outside does not get any tone if i forward my ip phone 7940 to my mobile.

All calls from outisde are coming into the PBX. PBX and ITS (Cisco 1760) are connected with a VIC-2BRI-NT/TE over Qsig.

The PBX calls my mobile via public telephony network

thusain · ‎09-26-2003

What version of IOS are you running?

Did you try adding progress_ind alert enable 8 under your pots dial peer that goes OUT to the PBX to call your mobile.

Taimoor

pf · ‎09-28-2003

IOS is 12.2(15)ZJ1. Yes. I tried, but it does not help.

Peter

bennypoole · ‎10-02-2003

you may need ansp (answer supervision) set to yes in your route data block. that would give ring back during call setup