10-13-2003 07:27 AM - edited 02-20-2020 11:02 PM
I purchased the PIX 501 for my home broadband connection. Prior to installing it, I am trying to learn it at work.
I can't get ethernet0 to accept a DHCP assigned ip. Probably something simple.
Should I be using a crossover or straight through cable ?
10-13-2003 07:43 AM
The command is ip address outside dhcp.
Check this link for more info.
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_62/config/pixclnt.htm#xtocid16
10-13-2003 08:20 AM
Good stuff but I still can't get connected to the LAN.
I have tried using a straight through cable and cross over. When I issue the command sho ip, the line protocol for ethernet0 is down for either cable. I know both cables are working.
I have even tried to statically assign an IP to ethernt0. still, the line protocol is down.
10-13-2003 09:02 AM
Stupid is as stupid does !!!!!!!!
Forget the support. Thanks anyway, but It helps to look at the switch speed. I had the PIX plugged into a 100mb switch.
Everything is working
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide