×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

MCS7800 Blue Screen during Unity install

Unanswered Question
Oct 15th, 2003
User Badges:

I had the OS loaded on the MCS7800. I removed the OS and tried to start over. When I inserted the Unity Platform Config disc 1 the install started, The blue screen occurred during second disc. The blue screen was mentioning something about inaccessable boot device. After the blue screen I tried to use the F1 utility on disc 1. I'm getting a message that says ERR013 No controllers were found on this host. I ran HPs erase Utility and tried to start over. Still no success. I don't think the controller went bad all of a sudden. I checked the cables in the server everything appears to be attached correctly.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion