×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

MC3810 DVM problem - glare problem

Unanswered Question
Oct 16th, 2003
User Badges:

In an MC3810 using a DVM card to the PBX and set up as E&M tie lines, I get the first call to go through no problem, but when trying to make additional calls (the PBX and DVM are set up for 6 channels) the additional calls do not go through, and the "show voice call" command shows that the PBX is stepping through the unused channels, but the 3810 registers glare on whichever channel the PBX attempts to use.

3810 is using 12.2(15)T1 - any ideas? Here is the voice part of the config:


controller T1 1

mode cas

framing esf

linecode b8zs

ds0-group 1 timeslots 19-24 type e&m-immediate-start



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
thomas.chen Tue, 10/21/2003 - 11:07
User Badges:
  • Silver, 250 points or more

You can put an analyser on the PABX at each end to ascertain what is the behavior of the PABX is at each end. If it is the issue with the PABX , then you can take it uo with the PABx vendor. Or else, you can try upgrading the IOS.

Actions

This Discussion